Reference Manual
00809-0100-4853, Rev AB
Operation and Maintenance
January 2017
37
Operation and Maintenance
Section 4 Operation and Maintenance
Calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 38
Field upgrades and replacements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 41
4.1 Section overview
This section contains information on operating and maintaining the Rosemount
™
3051S MultiVariable
™
F
OUNDATION
™
Fieldbus Transmitter (3051SMV). Each FOUNDATION Fieldbus host or configuration tool has
different ways of displaying and performing operations. Some hosts will use Device Descriptions (DD)
and DD Methods to complete device configuration and will display data consistently across platforms.
The DD can be found on the FieldComm Group website at FieldCommGroup.org
. There is no
requirement that a host or configuration tool support the features in the DD. For DeltaV™ users, the DD
can be found at EasyDeltaV.com
. The information in this section will describe how to use the basic
methods.
Based on the configuration ordered, some measurements (e.g. process temperature) and/or calculation
types (e.g. fully compensated mass flow, process variables only) may not be available. Available
measurements and/or calculation types are determined by the multivariable type and measurement
type codes ordered. See “Ordering information” on page 64 for more information.
4.2 Safety messages
Procedures and instructions in this section may require special precautions to ensure the safety of the
personnel performing the operation. Information that raises potential safety issues is indicated with a
warning symbol ( ). Refer to the following safety messages before performing an operation preceded
by this symbol.
Failure to follow these installation guidelines could result in death or serious injury.
Make sure only qualified personnel perform the installation.
Explosions could result in death or serious injury.
Do not remove the transmitter cover in explosive atmospheres when the circuit is live.
Before connecting an Emerson
™
Field Communicator in an explosive atmosphere, make sure the
instruments in the segment are installed in accordance with intrinsically safe or non-incendive field
wiring practices.
Both transmitter covers must be fully engaged to meet flameproof/ explosion-proof requirements.
Verify the operating atmosphere of the transmitter is consistent with the appropriate hazardous
locations certifications.
To Next Page
Need help?
General
