Emerson Bettis G4 Series User Manual

Installation, Operation and Maintenance Manual
VA-DC-000-1803 Rev. 2 July 2020
3
Section 1: Introduction
Introduction
1.4 Bettis Reference Materials
1.4.1 Assembly Drawing for G01-M18 through G10-M18 Double-Acting with
one Pneumatic Power Module and one Hydraulic Override Module use
part number VA115680.
1.4.2 M18 Manual Hydraulic Override System operating instructions part
number VA-DC-000-1879 with M18 Assembly Drawing part number
VA-ED-005-1120.
NOTE:
If you require a specic assembly drawing (IE: GXX-M3 OR HYD) please contact Emerson
Valve Automation Bettis by phone or email at Info.Bettis@EmersonProcess.com.
1.5 Service Support Items
1.5.1 Bettis module service kits.
1.5.2 For rod extension retainer nut tool part number, refer to the following Table.
NOTE:
These tools are required only when extension rod assembly (1 - 50) or (9 - 50) is removed or
when a new extension rod assembly is installed.
Table 1. G-Series Actuator Models
Actuator Model Bettis Part Number
G01 None required
G2 123616
G3/G4 117370
G5/G7 117369
G8/G10 117368
1.5.3 Commercial leak testing solution.
1.5.4 Non-hardening thread sealant.

Emerson Bettis G4 Series Specifications

General

Brand	Emerson
Model	Bettis G4 Series
Category	Controller
Language	English