InitialSetup
This section will guide you through the unit's initial setting
which includes selecting a language for your on-screen menu
and autoprogram, which automatically scans and memorizes
viewable channels.
Before you begin:
Make sure the unit is connected to antenna or cable.
2
After making all the necessary connections,
press (b to turn on the unit.
• It may take a few moments to turn on the unit for the
first time.
• [Initial Setup] menu appears automatically afterthe
unit isturned on.
Use A/V to select the on-screen language from the
choices (English / Espafiol/Fran_ais) on the right side of the
TV screen.
3 Use A/T to select [Antenna] for TV channels or [Cable]
for CATV channels, then press OK.
• [Autoprogram] will begin.
4
Use _/1_ to select the desired location setting, then
press OK.
• Select [Retail] store, the unit will be set up with
! :{7:¸
! iid
!IF
i¸-
predefined setting for retail displays. In this setting, the
]
power consumption may possibly exceed the limited .......
requirement of the ENERGY STAR®qualification.
{
• Select [Home], the unit is set to maximize the energy }
efficiency for home setting and it can be adjusted
through a choice of picture and sound quality according
to your preference ..............................
• When the initial setup is completed, the lowest
memorized channel with the confirmation message of
the location setting will be displayed on theTV screen. ::
Note
If you are not receiving a signal fl-om your cable service, contact the Cable
provide_:
If you press (D or- MENU during autoprogram, this setting will be canceled.
The initial autoprogram function can be executed for either- [Antenna] or
[Cable] only once.When you change the connection (Antenna / Cable),
set [Autoprogram] again. ,_* p.19
If there is no signal input fi_om the antenna terminal and no operation for
several seconds after-you turn on the unit, [Helpful Hints] appears. Follow
the instructions listed on theTV screen.
You must set [Home] in step 4. Othe_wdse, [Picture] and [Sound] settings
you adjusted will not be memorized after the unit goes to the standby mode.
_iii!:!!:
After an initial setup is completed...
• If you want to scan the channels automatically again,
[Autoprogram] ,,,_ p.19
• You can add the desired cable and analog channels
unmemorized by autoprogram.
[Add Channels] ,,,,*p.20
• If you want to change to another language.
[Language Selection] ,,,,*p.21
• If you want to change the location setting.
[Location] '"_'_p.30
15
EN
To Next Page
Loading...
Need help?
General
