Supplied Accessories
Owner's Manual
(I EHN27419)
Quick Start Guide
(1EH N27420)
Remote Control
(NH200UD)
Registration card
(1EHN27139)
AC power cord
(VVAV0t 62LW001) or
(VVAV0162LTE03) or
(VVAV152ZH N00t )
Batteries Screw kit
(AAA, 1.5V x 2) for attaching the base
(1ESA23096)
If you need to replace these accessories, please refer
to the part No. with the illustrations and call our toll
free customer support line found on the cover of this
manual.
Note
• if you lose the screws, please purchase N5 x 12 Phillips head screws a± your
local store.
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction.
2
3
Spread a thick and soft
cloth over a table as
shown.
Place the main unit face
up onto it. Make sure not
to damage the screen.At
least 2 people are required
for this step.
Insert 2 hooks under the
bottom of the main unit
into base holes. (shown by
arrow (i)), then move the
base in the direction as
shown by arrow @ until it
stops and the 6 mounting
holes are aligned.
Drive Phillips head screws
into the 6 threaded holes
at the bottom of the base
until they are tight.
To remove the base from this unit
• Unscrew the Phillips head screws on step 3,
After the screws are removed, move the base in the opposite direction as
shown by arrow (2) on step 2, then pull the base up toward the front of the
unit, Be careful not to drop the base when you remove it.
Note
• When attaching the base, ensure the± all screws are tightly fasCened, if the
base is not properly attached, it could cause the unit to fall. resulting in
injudes as well as damage to the unit,
• Nake sure to use a table which can support the weight of this unit and is
larger- than this unit,
• Nake sure the table is in a stable location.
• When attaching the base. ensure that FRONT t written on the base is
upward, if it's not upward, the 2 hooks don't fit in the base,
i
ii!i!i {
i 3!ii;
i! 'q
_iilS
! 2¸
y
ii _!{i
ii3!ii
i ilft'
ii 4
ii <i
Q
i (i?
iii!;ii
ii
,,,Ziii.....
; _7c,_
! (Zi
ili _i_'_i_
_i8;}i
ii l:::iii
i
Symbols Used in this Manual
The following isthe description for the symbols used in
this manual.Description refers to:
:DigitalTV operation
:Analog/CableTV operation
If neither symbol appears,the operation is applicableto
both.
Fixing the Unit onYour Furniture
Screw this unit on your furniture tightly using wood screws
(not supplied) in the 2 holes at the back of the base as shown.
, Recommended screw dimension :5,1 x 20 mm
rear of this unit
holes
Note
• When you remove this unit make sure to unscrew the wood screws from
yourWood Stand, Furn ture and other wood tern,
5
EN
To Next Page
Loading...
Need help?
General
