TROUBLESHOOTING
FAQ
ii!i i
i C:_
i!
i O
• Check the antenna or cable connection to the main unit.
Check the batteries of the remote control.
Check if there is an obstacle between the infrared sensor window and the remote
control.
Test the signal output. If OK, then possible infrared sensor trouble.
bly remote control does not [IR Signal Check] i,l_ p.34
work. • Aim the remote control directly at the infrared sensor window on the front of the unit.
What should I do? • Reduce the distance to the unit.
• Re-insert the batteries with their polarities (+/- signs) as indicated.
• When there is an infrared-equipped device such as PC near this unit, it may interrupt
the remote control signal of this unit.
• Move the infrared-equipped device away from this unit, change the angle of the infrared
sensor or turn off the infrared communication function.
How come the Initial setu
! i. P connect the REc0axiai Cable to the unit directly and run the initial setup:
appears every time I turn on ' 1 r "
-. . : • Hake sure to comp ere the channel scan befo e the unit goes to the standby mode.
thlS unit(
• Hake sure [Autoprogram] has been completed. Hll_p.19
• Autoprogram must be completed when you set up the unit for the first time or move it
to a location where previously unavailable channels are broadcast.
• The selected channel may not be broadcasting.
Why I cannot watch some RF • When [Autoprogram] is interrupted and not completed, some channels will not be
signal TV programs• received. Hake sure to complete. Hll_p.19
" The selected channel cannot be viewed by the [Child Lock] setting. Hll_p.27
" The unit requires some kind of antenna input.An indoor antenna
(VHF/UHF), an external antenna (VHF/UHF) or an RF coaxial cable from your wall
cable/satellite box needs to be plugged into the unit.
--- Check ifth e Eight input m0de iSselected by p_essing SOURCE Or using CH _i-.
[Switching Each tnput Mode] ,_ p.!7
H°w c°me there is nQ image ' CheCk the antenna or Cable c0nnecti0n to the Unit.
from the connected external
• ! ' _ When Usingthe ComponentVideo Connection checkthat the Green (Y) Blue (Pb/Cb)
aev ces" .................................. and Red (Pr!Cr) connectors are ConneCted to their corresponding Colored jacks on the
I unit.
• Many digital channels have alternate channel numbers.
Whenever I entered The unit changes the numbers automatically to the ones signifying the broadcasting
channel number, it changes station channel numben
automatically• These basic numbers used for previous analog broadcasts.
(e.g., input ch#30 auto change to ch#6.I)
I
Why are captions not displayed ......" Capt ons that are de ayed a few seconds beh nd theactua: . d a ogue are commonfor. . ve
entirely? broadcasts. Most captioning production companies can display a dialogue to maximum
Or, captions are delayed behind of 220 words per minute If a dialogue exceeds that ratelsetective editing is used to
the dialogue, insure that the captions remain up-to date With the current]R/screen dialogue[
How can Iset the clock ?
• There is no clock function on this unit.
31
EN
To Next Page
Loading...
Need help?
General
