OPTIONAL SETTING
Main Menu
This section describes the overview of the main menu
displayed when you press MENU. The main menu consists of
the function setting items below.
Press MENU.
Picture
Sound
Setup
_eatures
Language [Language Selection]
• ChangetheiViain Menu language.
[Picture Adjustment] Illl_"p.22
[Sound Adjustment] Illl_" p.22
[Autoprogram] i,l_ p.19
• You can automaticafl y scan the viewable channels.
[Channel List] i,l_ p.20
• The Channels that were autoprogrammed are in
this Channel fist, use CH +/- to access them.
[Add Channels] ,,l_ p.20
• You can add TV channels that were not found by
the autoprogram scan.
[Closed Caption] IIIIl_"p.24
• You can change the display closed caption format
which displays the dialogue ofaTV program or
other text information across theTV screen.
[Child Lock] ii,_ p.27
• You can set viewing limitations.
[Fun-Link] Illll_"p.29
• You can set Fun-Link options.
[Energy Saving Mode] Illll_"p.30
[Location] ,,l_ p.30
• Switch setting from [Retail] to [Home] to allow the
desired [Picture] and [Sound] mode to be kept in
memory
[Current Software Info] ,,l_ p.30
,,l_ p.21
Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you
move the unit to a different area after the initial setting, or if
you restore the DTV channels you deleted, it is recommended
to use Autoprogram to perform a new channel search.
Before you begin:
Make sure the unit is connected to antenna or cable.
t Press MENU to display the main menu.
2 Use A/T to select [Setup], then press OK.
3 Use A/Y to select [Autoprogram],then press OK.
4 Use A/T to select an appropriate option,then press OK.
• When connected toVHF/UHF antenna,
select [Antenna].
• When connected to CAT_, select [Cable].
• [Autoprogram] will begin.
• When the scanning and memorizing are completed, the
lowest memorized channel will be displayed.
Note
After setting [Autoprogram], using CH +/- on the remote control skips
unavailable programs automatically
if you are not receiving a signal fl-om your- cable service, contact the Cable
provide[
Jfyoupress_ or-MENUduringautoprogram,the setting will be canceled.
Evenif [Autoprogram]iscompleted,the channelsetqngwill be lostif the
AC powercord isunpluggedbeforethe unitgoesto the standbymodeby
pressing_.
ThePiNcodewill be requiredonceyouseta PINcodeinthe [ChildLock],
IIIIm_ p.27
if you want to change your PIN code, follow the instruction of
[Change PIN].III_ p.28
! Z2i
i!i
ii......
i i;,:c_
_i!!!:!
2'11
iiiii_!!_iii
i 2£:
iii!_}}iiii!i
<2
U::::i.......
i! !i?_i?
iii!i,li
iiiii!ii
i.......
_O
io
ii,:iii:
19
EN
To Next Page
Loading...
Need help?
General
