enphase IQ 7 User Manual

IQ 7 / IQ 7+ / IQ 7X / IQ 7A Installation and Operation
© 2020 Enphase Energy Inc. All rights reserved. 141-00044-02
4
Important Safety Information
Read this First
This manual contains important instructions for use during installation and maintenance of the IQ 7™ Series
Microinverters.
IMPORTANT: Enphase IQ Series Microinverters require the Q Cable and are not compatible with previous
Enphase cabling. An Envoy-S is required to monitor performance of the IQ Microinverters. The Q Accessories
work only with Enphase IQ Series Microinverters.
Product Labels
The following symbols appear on the product label and are described here:
WARNING: Hot surface.
DANGER: Refer to safety instructions.
DANGER: Risk of electrical shock.
Refer to manual
Double-insulated
Safety and Advisory Symbols
To reduce the risk of electric shock, and to ensure the safe installation and operation of the Enphase IQ System,
the following safety symbols appear throughout this document to indicate dangerous conditions and important
safety instructions.
DANGER:
This indicates a hazardous situation, which if not avoided, will result in death or serious injury.
WARNING:
This indicates a situation where failure to follow instructions may be a safety hazard or cause
equipment malfunction. Use extreme caution and follow instructions carefully.
WARNING:
This indicates a situation where failure to follow instructions may result in burn injury.
NOTE:
This indicates information that is very important for optimal system operation. Follow instructions
closely.
IQ 7 Series Microinverter Safety Instructions
General Safety
DANGER: Risk of
electric shock.
Risk of fire.
Only use electrical system components approved for wet locations.
Only qualified personnel should install, troubleshoot, or replace Enphase Microinverters or Enphase
Q Cable and Accessories.
Ensure that all AC and DC wiring is correct and that none of the AC or DC wires are pinched,
shorted or damaged. Ensure that all AC junction boxes are properly closed.
Do not exceed the maximum number of microinverters in an AC branch circuit as listed in the
manual. You must protect each microinverter AC branch circuit with a 20 A maximum breaker or
fuse as appropriate.

enphase IQ 7 Specifications

General

Brand	enphase
Model	IQ 7
Category	Inverter
Language	English