Epson EX31 User Manual

Maintaining the Projector 85
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu system.
1. Press the
Menu button on the remote control or on the
projector’s control panel. You see the main menu.
2. Select the
Reset menu and press Enter. You see this screen:
3. Select
Reset Lamp Hours and press Enter.
4. When you see the prompt, select
Yes and press Enter.
5. When you’re finished, press
Menu to exit.
Checking Lamp Usage
To check the number of hours the lamp has been used, press the
Menu button and highlight the Info menu. You see a screen like this:
note
The information displayed
depends on the input signal
currently selected.
If you have used the
projector for less than
10 hours, the hours are
listed as 0H.

Epson EX31 Specifications

Projection System

projection system	Epson 3LCD, 3-chip technology
projection method	Front/rear/ceiling mount
driving method	Epson Poly-silicon TFT Active Matrix

Display Performance

white light output	2500 lumens
color light output	2500 lumens
native resolution	800 x 600 (SVGA)

Power and Consumption

power supply voltage	100 – 240 V ±10%, 50/60 Hz
power consumption	280 W, 0.3 W standby
lamp type	200 W UHE

Operating Environment

operating temperature	41 ˚ to 95 ˚F (5 ˚ to 35 ˚C)
fan noise (normal mode)	34 dB
fan noise (eco mode)	29 dB

Dimensions and Weight

dimensions including feet	11.6" x 9.0" x 3.1"
dimensions excluding feet	11.6" x 9.0" x 3.0"
weight	5.1 lb