Evco EV3 CHIL User Manual

EVCO S.p.A. EV3 CHIL & EVD CHIL | Installer manual ver. 1.2 | Code 1443DCHILE124
page 12 of 46
3.3 Measurements and installation of EV3K01
The pictures below show the measurements of EV3K01; measurements are expressed in mm (inches).
To be installed on a panel with snap-in brackets provided.
The thickness of the panel on which the EV3K01 is to be installed must be between 0.8 and 2.0mm (0.031 and 0.078 in).
3.4 Installation precautions
- Ensure that the working conditions for the devices (operating temperatures, humidity, etc.) are within the set limits. See
the section TECHNICAL SPECIFICATIONS.
- Do not install the devices close to heat sources (heating elements, hot air ducts, etc.), equipment with a strong magnetic
field (large diffusers, etc.), in places subject to direct sunlight, rain, damp, excessive dust, mechanical vibrations or shocks.
- In compliance with safety regulations, the devices must be installed properly to ensure adequate protection from contact
with electrical parts. All protective parts must be fixed in such a way as to need the aid of a tool to remove them.

Evco EV3 CHIL Specifications

General

Brand	Evco
Model	EV3 CHIL
Category	Controller
Language	English