01-2018 5035 01 15
9. Turn the water funnel locking ring clock-
wise in order to secure the mixer to the
appliance.
After installing the components, it is
-Wash the mixer and add a few drops of the
sterilising solution into the various funnels.
-Then thoroughly rinse the components
in order to remove any sterilising solution
residue.
CLEANING THE NOZZLES AND
SPOUTS
Weekly or more frequently, depending on
how often the appliance is used and the
quality of incoming water, it is necessary
to sanitise the instant beverage dispensing
ducts and nozzles.
To clean the nozzles, proceed as follows:
1. Pull down the nozzle-moving handle.
2. Remove the cover and disconnect the
hoses from the nozzles.
3. Disconnect the coffee dispensing hose
from the flow divider nozzle.
4. Unhook the flow divider nozzle from the
nozzle support.
5. Remove the flow divider, milker nozzle (if
present) and the instant beverage nozzles.
6. For models with a cappuccino maker,
separate all the parts of the milker nozzle.
7. Proceed to sanitise all the components,
taking care to mechanically remove
residues and visible films using swabs or
brushes, if necessary.
8. Clean the spouts (if present) with a cloth
that has been dampened with sanitising
solution.
moDEls witH a cappucciNo makEr
1
4
2
3
5
Fig. 12
1. Nozzle-moving handle
2. Milker nozzle
3. Instant beverage nozzles
4. Movable nozzle cover
5. Flow divider nozzle
moDEls witHout a cappucciNo makEr
4
2
Fig. 13
1. Nozzle-moving handle
2. Movable nozzle cover
3. Coffee nozzle
4. Instant beverage nozzles
To Next Page
Loading...
Need help?
General
