01-2018 5035 01 21
Chapter 2
Installation
The installation and the subsequent main-
tenance operations must be carried out
with the appliance connected to the
power supply and therefore by specialised
sta, who are trained to use the appliance
and have been informed of the specic
risks deriving from such a situation.
The appliance needs to be installed in a dry
environment, with a temperature between
2°C and 32°C and cannot be installed in
environments where jets of water are used
for cleaning (e.g. large kitchens, etc.).
The appliance must be installed in
environments where it can be overseen
When the appliance has been in-
stalled, the hydraulic circuits and the
parts that come into contact with the
food products need to be sterilised in
order to eliminate any bacteria which
could have formed while the machine
was in storage.
UNPACKING THE APPLIANCE
After removing the packaging, check the
condition of the appliance.
If any doubts should arise, do not use the
appliance.
they are a potential source of danger.
The packaging materials need to be dis-
posed of in authorised waste disposal cen-
tres. Recyclable materials should be given
to specialised recycling companies.
Important!
The appliance must be positioned on a lev-
elled surface, so that the maximum inclina-
tion does not exceed 2°.
MAIN SWITCH AND SAFETY
MEASURES
maiN switcH
The (manual) main switch cuts o the
power to the appliance and is positioned
behind the solid residue container.
When carrying out normal cleaning and
product loading tasks, the appliance does
not have to be switched o.
safEty mEasurEs
The routine cleaning and product loading
tasks can be performed safely.
The unit has magnetic sensors which de-
tect:
-The closing of the door
-The presence of the containers
-The presence of the residue containers
In the absence of one of the listed condi-
tions, the appliance is disabled.
This appliance is equipped with a magnet
which allows the appliance to operate with
the door open.
The magnet must under no circumstances
be left inside the appliance, it must be kept
by the sta who are trained to use it.
2
3
Fig. 17
1. Line fuse
2. Main switch
3. Magnetic door sensor
To Next Page
Loading...
Need help?
General
