EVS XT[2] User Manual

XT Series DISK RECORDER - Version 10.03 - Hardware
Technical Reference Manual
Issue
10.03.B
EVS Broadcast Equipment SA
–
July 2010
29
2.6 RS422 CONNECTOR
The RS 422 cable must be wired PIN TO PIN following the above diagram. Use
shielded cable to avoid electromagnetic interference on long distances.
Important
The Reset command from the Remote is sent through the Pin n°5 of
RS422 connector. This function should be disabled when the controller
on RS422 #1 is not an EVS controller
(refer to the section ‘MTPC Board’
on page 59 of this manual).
The technical specifications for the RS422 connector are the following:
• 19200 bauds
• No parity
• 8 data bits
• 1 stop bit

EVS XT[2] Specifications

General

Brand	EVS
Model	XT[2]
Category	Server
Language	English