EVS XT[2] User Manual

Issue
10.03.B
XT Series DISK RECORDER
–
Version 10.03 - Hardware Technical Reference
EVS Broadcast Equipment SA
–
July 2010
54
Æ
if check is successful:
led 3 on (green)
Polling for PC
commands
Æ
led 4 on (green)
Switching to enhanced
mode
Æ
led 5 on (green)
Executing PC
commands until
execution requests end
led 6 on (green)
Jump to SDRAM and execute microcode
CONNECTORS
On the XNet[2] module (SDTI) :
J3: Not used
J4: Not used
J5: OUT connector for XNet[2] (SDTI network 540/1485Mbps without
relay)
J6: IN connector for XNet[2] (SDTI network 540/1485Mbps without relay)
Note
J5 must be used with J6. Never use J3 with J5 or J4 with J6.
GIGABIT CONNECTORS
The two Gigabit connectors of the card are connected to the two Gigabit ports of
the backplane.
The Gigabit connectors must be on a network that supports Jumbo Frames of (at
least) 9014 bytes Ethernet frames. One of the tested switch belongs to the Cisco
3750 G family, for example the WS-C3750G-24T-S.
For more information, refer to the Multicam Configuration manual for setting up
the IP addresses.

EVS XT[2] Specifications

General

Brand	EVS
Model	XT[2]
Category	Server
Language	English