EVS XT[2] User Manual

XT Series DISK RECORDER - Version 10.03 - Hardware
Technical Reference Manual
Issue
10.03.B
EVS Broadcast Equipment SA
–
July 2010
31
Analogue DB15 Connectors
Pin
#
Sub-DB15 #1
Inputs 1-4 (mono)
Sub-DB15 #2
Inputs 5-8 (mono)
Sub-DB15 #3
Outputs 1-4 (mono)
Sub-DB15 #4
Outputs 5-8 (mono)
1 GND GND GND GND
2 Analogue input 1 + Analogue input 5 + Analogue output 1 + Analogue output 5 +
3 GND GND GND GND
4 Analogue input 2 + Analogue input 6 + Analogue output 2 + Analogue output 6 +
5 GND GND GND GND
6 Analogue input 3 + Analogue input 7 + Analogue output 3 + Analogue output 7 +
7 GND GND GND GND
8 Analogue input 4 + Analogue input 8 + Analogue output 4 + Analogue output 8 +
9 Analogue input 1 - Analogue input 5 - Analogue output 1 - Analogue output 5 -
10 GND GND GND GND
11 Analogue input 2 - Analogue input 6 - Analogue output 2 - Analogue output 6 -
12 GND GND GND GND
13 Analogue input 3 - Analogue input 7 - Analogue output 3 - Analogue output 7 -
14 GND GND GND GND
15 Analogue input 4 - Analogue input 8 - Analogue output 4 - Analogue output 8 -
2.8 CONNECTING MULTIPLE EVS VIDEO
SERVERS ON XNET
The XNet network is composed by several EVS video servers all connected with a
75-Ohm coaxial cable (BNC).
The exchange between systems is operated through the SDTI interface at 540 or
1485 Mbps.
On XT[2] servers there are one pair of SDTI connectors: XNet[2] Non-Relay
connectors that can be used at 540 or 1485 Mbps.
The SDTI loop is closed only when the Multicam software is started. It is therefore
recommended to use XHub when using Non-Relay connectors to avoid network
interruptions.
The XNet requires a network server dedicated to the management of the Database
shared among all LSM-EVS video servers. This is assigned to one of the LSM-EVS
servers on the network. The EVS server acting as the network server can of
course be used for standard LSM/video server operation.

EVS XT[2] Specifications

General

Brand	EVS
Model	XT[2]
Category	Server
Language	English