PRODUCT FUNCTIONALITY
33
Chapter7
The boiler you have purchased uses pellet fuel. This type of material is obtained from natural waste from
the machining of wood. By means of a special process that does not require the use of any binding agent
and additive, the waste is compressed in industrial machinery under high pressure and they become
solid wooden pellets. IT IS PROHIBITED to burn non-pelletised raw materials inside our boilers. The failure
to comply with these prescriptions voids all guarantees and could jeopardise the safety of the appliance.
The following recommendations must be followed the rst two or three times the boiler is ignited:
no children must be present because the vapours emitted can be noxious to health. Adults should
also avoid long stays.
Do not touch the surfaces as they could still be unstable.
Air the room well several times.
The hardening of the surfaces is terminated after several heating processes.
This appliance must not be used to burn waste.
Before switching the boiler on the following points must be veri ed:
the feed-box must be full of pellets
the combustion chamber must be clean
The brazier must be completely free and clean
check the hermetic closure of the re door and the ash drawer
make sure the power supply cable is connected correctly
the bipolar switch in the rear right part must be positioned on 1
The functioning procedure will follow these points:
1.Cleaning the trapdoor (trapdoor blows in automatic mode)
2.Ignition
3.Start-up
4.Functioning
5.Switch-o
IGNITION
A. Press key 1 for 3 seconds.
After a check-up of about 8 seconds, the machine will start to clean the brazier, by striking the trapdoor
and then starts the ignition process,following these 3 points:
1.Power supply to the ign-plug
2. Power supply to the pellet feed motor
3. Start-up of the fumes motor.
If after a maximum of 18 minutes the machine has not ignited, the “no ignition” alarm occurs.
In the case of alarm due to no ignition, follow these points:
1.Wait a minimum of 10 minutes without pressing any button on the display, as there is a safety delay of
10 minutes. If a button is pressed within the 10 minute delay time, the delay re-starts the count from the
start.
To Next Page
Loading...
Need help?
General
