To change the time, use the keys and .
Press to return to the initial alarm configuration screen, or press to return
to the alarm configuration screen and confirm the changes.
0.4.3 E5: Water inlet fault
Press the key on the error configuration screen to modify error 5, water inlet fault. The
time after which the error is displayed on the screen can be configured.
The error time can be configured. Range, from 5 to 30 minutes. The default time programmed is
5 minutes.
To change the time, use the keys and .
Press to return to the initial alarm configuration screen, or press to return
to the alarm configuration screen and confirm the changes.
0.4.4 E6: Heating fault
Press on the error configuration screen to cancel 6, heating fault. By default it is enabled.
To Next Page
Loading...
Need help?
General
