Press to return to the initial SAT screen.
0.4.5 Set steam inertia
Pressing on the icon the display would show a screen to be able to set the vapor inertia in
percentage.
This percentage is how long before the slogan they have to cut to heat. For example, if it is set to
10%, it would stop heating 10% before the set-up (i.e. when reaching 90%). This percentage will be
limited from 0% to 20% and default will be set at 10%. In Steam Machines This option will be active and
set to 10% by default.
0.5 Advanced maintenance
On the Maintenance screen, select the icon , and press “OK” to go to the advanced
maintenance screen. A special password (0888) is required to access this section.
To Next Page
Loading...
Need help?
General
