Supplemental Owner’s Manual
The optional boom arm may be installed on
any CT-series vacuum except for the CT-Mini
and CT-Midi. The boom arm is an overhead
carrier for the vacuum hose and power cord
for your power tool to keep them above your
working area. The boom arm may be installed
facing toward the front of the vacuum or
toward the rear of the vacuum, depending on
your preferences and work area setup. (Refer
Changing Forward/Rearward Direction
applicable CT-series vacuums. However, a
prerequisite to installing the boom arm is that
the optional transport handle is installed on the
vacuum, and the handles will vary for different
Transport Handle
on page 13 for the procedure to install the handle on your
The boom arm may be ordered separately or as a complete
vacuum model, and include the transport handle and any
other components necessary to install the boom arm.
Unpack the boom arm components. R
the protective web/netting from the tubes.
Transport Handle
CT-series vacuum as described on
page 13
Power Cord
Bracket (Reel)
” on page 12 and replace it with the
boom arm support bracket shown below. (The power cord
reel interferes with the position of the mast.)
Mounting
Holes
Support
Bracket
Assembling the Outriggers
The outriggers stabilize the vacuum to prevent it from
tipping from the weight of the boom arm. They should be
installed in the same direction (forward or rearward) that
aces to one of the outrigger tubes
riage bolt through the cross brace so the square shank of
the thumbscrews slightly loose.
Cross Brace
Carriage Bolt
& Thumbscrew
Outrigger
aces, and assemble them to the other
outrigger tube using the remaining carriage bolts and
Cross
Braces
Outriggers
Mast
Outriggers
Cross-
braces
Extension Hose
and Coupling
Tube
Clamps
Main
Boom
Boom
Tip
Extension
Cord
Boom
Pivot
To Next Page
Loading...
Need help?
General
