Changing the Filter Element
emove the motor housing from the collection canister
page 8
, and turn the motor housing
aise the green handle (which also serves as the latch)
A
B
Front
Filter
Holder
Handle
(Latch)
seal is facing toward the vacuum motor housing.
Filter
Seal
Holder
e sure there are no scratches, gouges,
or foreign materials that can impede the effectiveness of
aised and facing toward the front of the
When using the CT-vac for damp or wet extraction, it is
ister, incoming moist air will cause the existing dust in the
collection bag to get wet and cake to the inside of the bag.
the suction of the vacuum. Likewise, if moist air reaches the
When returning to dry collection, it is important to replace
dry the interior of the vacuum and the collection hose so
that incoming dry dust does not adhere to the remaining
water inside the canister.
Wet Filter
emove the motor housing from the collection canister as
page 8
emove the dust collection bag. (Don’t close the dust
gate unless you intend to dispose of the bag. However,
the procedure to the left.
Wet
Filter
Collection
Bag Removed
After wet collection is complete, empt
o facilitate drying, you may wish to run the vacuum for
To facilitate drying, you may wish to run the vacuum for T
a few minutes before replacing the collection bag and dry
To Next Page
Loading...
Need help?
General
