4 Web Configuration Guide
1. Select Network in the navigation bar and select OLT
Authentication in the left link bar to open the OLT
authentication configuration tab, as shown in Figure 4.10.
Figure 4.10 OLT Authentication
2. Configure the parameters as required. Table 4.5 describes the
parameters.
3. Click Apply to save the configuration information. The
configuration will take effect after the ONU is rebooted.
Table 4.5 Parameters for OLT Authentication
Item Description
LOID
Sets the logical SN user name. This item is
configurable when the
ONU uses the logical
ID authentication.
Logic
Password
Sets the logical SN password.
Password
Sets the authentication password when the ONU is
authenticated by password.
4.4 Security
The following introduces how to configure the firewall, remote
control, DDOS and HTTPS in the Web GUI.
44
To Next Page
Loading...
Need help?
General
