HG6543C Product Manual
Table 3-3 Advanced Setting Parameters of Wireless Network (Continued)
Item
Description
Default Key
Select Key1 to Key4; that is, select one of the four
configured network keys.
This item should be
configured when the
authentication mode
is OPEN and the
WEP encryption is
enabled or the
authentication mode
is SHARED or
WEPAUTO.
WEP Key 1 to
WEP Key 4
Enter the key value and select the key value type. At
least enter the item selected in Default Key.
u If ASCII is selected, you should enter a key value
containing 5 to 13 characters.
u If Hex is selected, you should enter a
hexadecimal figure containing 10 to 26
characters.
Note:
Pressing the Apply button will validate a single SSID choice
configuration item. If you do not click Apply after modifying the SSID 1
setting, the modification will not take effect.
If the SSID1 setting is modified, the factory default wireless network
account will be invalid.
If you forget the customized wireless network account, restore the factory
default account by pressing down the Reset button for more than 5
seconds.
3.3.1.33.3.1.3 Wi-Fi Control
Configure parameters of the 2.4G wireless network, such as Wi-Fi power and
number of WIFI connections.
1. Select Network in the navigation bar, and then select Wlan Settings→WIFI
Control in the left link bar to open the WIFI control setting page for the 2.4G
wireless access service, as shown in Figure 3-12.
32
Version: A
To Next Page
Loading...
Need help?
General
