13
9 BEFORE INSTALLATION
IMPORTANT!
Ensure your appliance is not exposed to any heat generating appliances eg cooktop, oven or dishwasher.
The refrigerator has front and rear rollers for moving forward and backward. Do not move the refrigerator sideways to avoid damaging the rollers or floor covering/surface.
The refrigerator must be installed by a qualified installer, or Fisher & Paykel trained and supported service technician to avoid faulty electrical connection and water leaks.
All connections for water, electrical power and grounding must comply with local codes and ordinances and be made by licensed personnel when required.
Avoid installation of the refrigerator/s under a ground fault circuit interrupter (GFCI).
Ensure the refrigerator is installed properly. Improper installation that results in refrigerator failure is not covered under the refrigerator warranty.
Check the installation location
Check the cabinetry
Check the dimensions of the cabinetry (width, depth, height, floor level, finished
alcovereturns).
Ensure that the ventilation openings in the cabinetry are clear of obstruction.
For integrated installation, a finished return of solid material is required across the top
andsides of the new or existing alcove.
It is recommended that the return should be at least 3 1/2” (89mm) deep across the sides.
Refer to ‘Cavity Dimensions’ prior to installation of the refrigerator.
Check the power supply connection
Ensure that there is a separate power outlet for each refrigerator.
Avoid sharing the power point with other appliances to prevent accidental switching off
ofthe refrigerator.
For power requirements, refer to the information on the serial plate. This is located athe
front right-hand side of the drawer when open.
Ensure your refrigerator is properly grounded (earthed).
Connect the refrigerator to the electrical supply (115VAC, 60Hz) with fitted plug and lead.
We recommend to use an isolating switch that is easily accessible to the user after the
refrigerator is installed.
Follow the National Electrical Code and all local codes and ordinances when installing
thisrefrigerator.
Check the water supply connection (for Ice & Water models only)
Your product must be installed by a qualified refrigerator installer as incorrect plumbing
canlead to water leaks.
Fisher & Paykel is not liable for damage (including water damage) caused by faulty
installation or plumbing.
Check your refrigerator
Ensure that your refrigerator is the correct model as per your order.
Ensure that the packaging is not damaged upon delivery.
Check that the components and install kits are complete.
Prepare the door panel set
The refrigerator does not include a door panel set.
Custom door panels are designed only for non-Water dispensing models.
To complete the integrated refrigerator for non-Water dispensing models, the
customershould supply their own custom door panel set.
– All the hardware required to mount the door panel sets to the refrigerator doors
issupplied with the refrigerator.
Door panel sets are available through your Fisher & Paykel dealer.
– Fisher & Paykel door panel sets are available (Stainless steel door panels)
modelnumbers: RD3672 and RD3672U.
Handle sets are optional for custom door panels and can also be purchased through
yourFisher & Paykel dealer.
To Next Page
Loading...
Need help?
General
