FLIR K 5 Series User Manual

Operation
12
12.2 Removing the battery (FLIR K65)
12.2.1 Procedure
Follow this procedure:
1. Unscrew the Torx T20 screw and pull up the latch.
CAUTION
Make sure that you do not use a torque value that is more than 80 Ncm on the Torx T20 screw.
Damage to the camera can occur if you do not obey this.
2. Pull out the battery from the battery compartment.
12.3 Charging the battery
WARNING
Make sure that you install the socket-outlet near the equipment and that it is easy to get access to.
12.3.1 General
Charge the battery for 4 hours before starting the camera for the first time, or until the
blue battery condition LED glows continuously.
12.3.2 Procedure
Follow this procedure:
1. Put the battery in the standalone battery charger.
2. Connect the power supply cable plug to the connector on the standalone battery
charger.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the blue battery condition LED glows
continuously.
#T559946; r. BA/41926/41970; en-US
26

FLIR K 5 Series Specifications

General

Brand	FLIR
Model	K 5 Series
Category	Thermal cameras
Language	English