Removing the spare tire
1. Wagon only: Open liftgate and
lift flap in the carpeting on the rear
tub cargo floor to expose the hex
nut. Insert the lug nut wrench on
the hex nut in cargo floor.
Cargo van only: Lift flap in mat to
expose hex nut. Insert extension
tool through access hole and engage
hex nut. Place lug wrench onto end
nut of extension tool.
2. Turn the wrench
counterclockwise until cable is slack
and tire can be slid rearward.
3. Remove the primary retainer from
the center of the tire.
Note: Do not stow the full size tire or any flat tire under the vehicle.
Stowing the primary tether
Note: If no tire is to be stowed
under the vehicle, raise the primary
tether by turning the wrench
clockwise until the hex nut ratchets.
2006 Freestar (win)
Owners Guide (post-2002-fmt)
USA (fus)
Roadside Emergencies
245
To Next Page
Loading...
Need help?
General
