To Next Page

To Previous Page

Zone variation mode

1. Determine which magnetic zone

you are in by referring to the zone

map.

2. Turn the ignition to the ON

position.

3. Press and hold the momentary

push-button for approximately 4

seconds, until VAR is displayed,

then release it. (Pressing the

momentary push-button for 8

seconds de-calibrates the

compass—see Compass

Calibration Mode).

4. Press the button to increment the

VAR number to the desired VAR

number. Wait 5 seconds without

button activity and the compass will return to the heading mode.

Note: If there is no button activity for 5 seconds, the compass writes the

displayed zone VAR number to memory and exits Zone Variation Mode

Compass calibration mode

1. Press the momentary push button

and hold it for more than 8 seconds.

After 8 seconds, CAL is displayed,

then release it.

Note: After button release CAL will

be displayed with a heading. The

compass is now de-calibrated and

enters the Initial AutoCal Mode.

2. Drive the vehicle in a tight circle

in a magnetically clean area such as

an open parking lot. Drive at a rate not faster than 15 seconds per circle

5 mph (8km/h).

123

6 7 8 9 1011

2006 Freestar (win)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

Ford 2006 Freestar User Manual

Questions and Answers: