71
General: Custom Energy Savings Settings
19 – AUTO CHANGEOVER SET POINT OFFSET
00-04 (01°F* default setting) Select the difference between the guest-selected
set point and the heat and the cool set point when the thermostat is in
the automatic temperature control mode.
This value plus the 1st stage differential defined in steps 02 and 04,
defines the temperature at which the thermostat would automatically
change heating/cooling modes.
This feature allows adjusting the deadband between the heat and the
cool set points in automatic changeover mode in order to avoid the
system from bouncing back and forth between heating and cooling
under normal operating conditions.
To Next Page
Loading...
Need help?
General
