Error Message Cause Action
No Paper T1
The machine failed to feed paper
from the indicated paper tray.
Do one of the following:
• Refill paper in the paper tray indicated on
the LCD. Make sure the paper guides are
set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
• Do not overfill the paper tray.
No Toner
The toner cartridge or the toner
cartridge and drum unit assembly
is not installed correctly.
Remove the toner cartridge and drum unit
assembly. Remove the toner cartridge from the
drum unit, and reinstall the toner cartridge
back in the drum unit. Reinstall the toner
cartridge and drum unit assembly back in the
machine. If the problem continues, replace the
toner cartridge with a new one.
Out of Memory
The machine’s memory is full. Press and hold Go for about two seconds and
reduce the print resolution.
Print Data Full
The machine’s memory is full. Press and hold Go for about two seconds and
delete the previously stored print data.
Print Unable ## The machine has a mechanical
problem.
• Press and hold to turn the machine off,
wait a few minutes, and then turn it on
again.
• If the problem continues, contact Fuji Xerox
customer service.
Replace Drum
It is time to replace the drum unit. Replace the drum unit with a new one.
See Related Information: Replace the Drum
Unit.
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter.
See the instructions included with the new
drum unit.
Replace Toner
The toner cartridge is at the end of
its life. The machine stops all print
operations.
Replace the toner cartridge with a new one.
Self-Diagnostic
The temperature of the fusing unit
does not rise to a specified
temperature within the specified
time.
Press and hold to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
The fusing unit is too hot.
Size Error
The paper size defined in the
printer driver is not supported by
the defined tray.
Choose a paper size supported by the defined
tray.
Size Error DX
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
Press and hold Go for about two seconds (if
required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper size available for automatic 2-sided
printing is A4.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
Size Mismatch
The paper in the tray is not the
correct size.
Load the correct size of paper in the tray
indicated on the LCD and set the size of paper
for the tray. Press Go.
168
To Next Page
Need help?
General
