Manufacturer’s notes
CE marking
CEmarking
CE marking for d evices with radio c om ponent
This equipment complies with the requirements of Directive 1999/5/EC of the
European Parliament and Commission from 9 March, 1999 governing Radio
and Telecommunications Equipment and mutual recognition of conformity.
This e quipm ent can be used in the following countries:
Belgium Bulgaria Denmark
Germany
Estonia Finland France
Greece
UK Ireland Iceland Italy
Latvia Liechtenstein Lithuania Luxemb ourg
Malta The
Netherlands
Norway Austria
Poland Portugal Rumania
Sweden
Switzerland Slovakia Slovenia Spain
Czech Republic
Hungary
Cyprus
Contact the corresponding gove rnment office in the respective country for
current information on possible operating restrictions. If y our country is
not included in the list, then p lease contact the corresponding supervisory
authority as to whether the use of this product is permitted in your country.
Regulatory notices
If there is no FCC logo and also no FCC ID on the device then this device is
not approved by the Federal Communications Commission (FCC) of the USA.
Although it is not explicitly forbidden to travel in the US trading area carrying this
device, to avoid trouble at customs clearance, F ujitsu Technology Solutions GmbH
recommends not to bring this device into th e US trading area.
Regulatory information for noteb ooks without radio device
Regulatoryinf ormation
NOTICE:
Changes or modifications no t expressly approved by F ujitsu Technology Solutions
could void this user’s authority to operate the equipment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmfu l interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment doe s cause harmful interference to radio or television
reception, which c an be determined by turning the equipm ent off and on, the user is encouraged
to try to correct the interference b y one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
68 Fujitsu
To Next Page
Loading...
Need help?
General