Manufacturer’s notes
FCC regulatory information for notebooks with radio device
Regulatoryinf ormation
Federal Communication s Commission statement
This device complies w ith Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of th is device.
FCC Interference Statement
This equipment has been tested and fou nd to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to p rovide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a part icular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference b y one or more of t he following measu res:
1. R eorient or relocate the receiving antenna.
2. In crease the distance betw een the equipment and the receiver.
3. C onnect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4. C onsult the dealer or an experienced radio/TV technician for help.
Please note the following regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has been evaluated under FCC Bulletin OE T 65C and found compliant with the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF
Exposure from r adio frequency devices. The radiated o utput power of this radio device is far below
the FCC radio frequ ency exposure limits. Nevertheless, this device shall be used in such a man ner
that the potential for human contact during normal operation is minimized. W hen using this device, a
certain s epa ration distance betw een ante nna and nearby persons must be maintained to ensure RF
exposure compliance. In order to comply with RF exposure limits establishe d in the ANSI C95.1
standards, the distance between the antennas and the user should not be less than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and authorisatio n fo r u se
Radio-frequency electromagnetic energy is emitted from the wireless devices. The energy levels
of these emissions, however, are far much less than the electromagnetic energy emissions from
wireless devices such as mobile phones. Radio devices are safe for use by consumers because
they operate within the guidelines found in radio frequency safety standards and recommendat ions.
The use of the radio devices may be restricted in some situations or environments, such as:
• on board a n airplane, or
• in an explosive environment, or
• in situations where the interference risk to other devices or services is
perceived or identified as harmful.
In cases in which the policy rega rding use of radio devices in specific environments is not
clear (e.g., airports, hospitals, chemical/oil/gas industrial plants, private buildings), obtain
authorization to use these devices prior to operating th e equipment.
72 Fujitsu
To Next Page
Loading...
Need help?
General