Important notes
Important notes
ImportantnotesNotes
In this chapter you will find information regarding s afety which it is essential to
take note of when working with your device.
Safety instructions
This device complies wit
h the relevant safety regulations for data processing equipment,
including electronic of
fice machines for u se in an office environment. If you have
any que stions about whe
ther the device can be used in the intended environment,
please contact y our sal
es office or our Service Desk.
• The display surface of
the device is sensitive to pressure and scratches. You should therefore
be careful with the dis
play surface in o rder to avoid lasting damage (scra tche s).
• If the device is brought into the installation site from a cold environment, condensation
can form. Before operating t he device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
• When installing an
d operating the device, please observe the notes on environmental
conditions in Chap
ter "
Technical specification", Page 33 as well as the instructions in
Chapter "
Setting
up an e r gonom ic video workstation", Page 12.
• To ensu re sufficient ventilation, the air inlet and outlet openings of the device must be kept clear.
• The device autom
atically sets itself to the correct voltage within the range from 100 V to 240 V.
Make sure that t
he local mains voltage is neither higher nor lower than this range.
• Ensure that the power socket on the device and the mains outlet are freely accessible.
• The ON/OFF swi
tch does not disconnect the monitor from the mains voltage. To disconnect
fully from the
mains supply, disconnect the power plug from the socket.
• The device is equipped with a power cable that complies with safety standards.
• Use the suppl
ied power cable only.
• Lay the cables in s uch a way that they do not create a hazard (danger of tripping)
and cannot be damaged. When connecting the device, observe the relevant
notes in chapter "
Connecting the device", Page 17.
• No data tra
nsfer c ables should be connected or disconnected during a thunderstorm.
• Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get
inside the device (danger of electric shock, short circuit).
• The devic
e is not waterproof ! Never immerse the device in water and protect
it from s
pray water (rain, sea water).
• In an emergency (e.g. damaged casing, operation controls or cables, penetration
of liquids o r foreign matter), switch off the device, disconnect the power plug
and contact your sales outlet or our Service Desk.
• Repai
rs to the device must only be performed by qualified technicians. Unauthorised opening
and in
correct repair may greatly endanger the user (electric shock, fire risk).
• Only use the screen resolution se ttings and refresh rates specified in Chapter
"
Technical specifica tion", Page 33. Otherwise you may damage the device . If you
are in any doubt, contact your sales outlet or our Help Desk.
•Usea
screen saver with moving images and activate the power management for
you
r m onitor t o p revent still images from "burning in".
• If you opera te the device with the swivel arm or wall bracket, it m ust not be turned by 180°.
Fujitsu Technology Solutions 7
To Next Page
Loading...
Need help?
General