Important notes
• The device must only be operated in landscape mode (0°) and portrait mode (90°). The
control buttons are located in the middle of the bottom of the monitor in landscape mode
(0°) and at the left-hand side of the monitor in portrait mode (90°).
• Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
• We recommend that you place your device on a durable, non-slip surface. I n view
of the m a ny different finishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
• To ensure sufficient ventilation, the air supply and air ou tlet op enings of
the monitor must never b e blocked.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is necessary to replace the original cable se t.
• The female/male receptacles of the c ord set must meet I EC60320/CEE-22 requirement s.
• The cable has to be HAR-certified or VDE-certified. The mark HAR or
VDE will appear on the outer sheath.
• For devices w hich are mounted on a desk or ta ble, type SVT or SJT cable sets may be
used. For devices which sit o n the floor, only SJT type cable sets may be used.
• The cable set must be selected according to the rated current for your device.
• If necessary, replace the original power cable with a regular ground ed 3-core ma ins lead.
Transporting the d evice
Device,Transpo rtatio nRetransportation
Transport all parts separately in the ir original packaging or in a packaging which
protects them from knocks an d jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximate ly the same temperature as the installation site.
8 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General