Importan t notes
• The device must only be operated in landscape mode (0°) and p ortrait mode (90°). The
control buttons are located in the middle of the bottom of the mon itor in landscape mo de
(0°) and at the left-hand side of the monitor in portrait mode (90°).
• Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
• We recommend that you place your device on a durable, non-slip surface. In view
of the many different finishes and varnishes used on furniture, it is p ossible that th e
feet of the device may mark the su rface they stand on.
• To ensure sufficient ventilation, the air supply and air outlet op enings of
the monitor m ust never be blocked.
• The device must be connected to protective earth.
• To prevent possible hearing da m age, do not listen at high volume levels for long periods.
• Warning for excessive sound pressure from earphones and headphones:
Excessive sound pressure from earphones and headphones can cause hearing loss.
Adjustment of the equalizer to maximum increases the earphones and headphones
output voltage and therefore the sound pressure level.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is n ece ssary to replace the original cable set.
• The female/male recep tacles of the c ord set must meet IEC60320/C E E-22 requirements.
• The cable has to be HAR -certi fied or VDE-certified . The ma rk HAR or
VDE will appear on the outer sheath.
• For devices which are mounted on a desk or table, type SVT or SJT cable sets may be
used. For devices which sit on the fl oor, only SJT type cable sets may be used.
• The cable s et must be selected according to the rated c urrent for your device.
• If ne cessary, replace the original power cable with a regular grounded 3-core mains lead.
Transporting the device
Device,Trans porta tionRetransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be u sed ,
condensation m ay occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
