Fujitsu ETERNUS User Manual

Chapter 2 Setup
> 2.2 Modifying the ETERNUSmgr Setup
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
17
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
Device Specific Setup Parameters (differences only)
2.2 Modifying the ETERNUSmgr Setup
This section explains how to change the setup of ETERNUSmgr for Solaris OS, HP-UX, AIX,
Linux, or Windows®.
Use a text editor to modify the setup file. Any text editor can be used as none has been specified.
2.2.1 ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux Procedure
This section explains what to do for the Solaris OS, HP-UX, AIX, and Linux versions of
ETERNUSmgr.
The procedure shown is for changing the settings that were set during installation.
This explanation uses ETERNUSmgr's default installation directory "/opt/FJSVgrmgr/" as an
example.
Procedure
1 Confirm the contents of the installation directory.
Make sure that the necessary files and directories (stxchk, _STXPOLL.INI,
STXPOLL_1.INI, stxpoll, stxpolld, www/) have all been installed.
# ls /opt/FVSVgrmgr/
stxchk _STXPOLL.INI STXPOLL_1.INI stxpoll stxpolld www/
Setting item Parameter
Target Type
ETERNUS
GR710, GR720,
GR730,
ETERNUS3000
ETERNUS
GR740, GR820,
GR840,
ETERNUS6000
ETERNUS DX400
series,
ETERNUS DX8000
series,
ETERNUS2000,
ETERNUS4000,
ETERNUS8000
Target Device
(may be
changed)
TARGET_TYPE
Default setting is
"GR710",
"GR720",
"GR730", or
"ETERNUS3000"
Default setting is
"GR740",
"GR820",
"GR840", or
"ETERNUS6000"
Default setting is
"ETERNUS DX400",
"ETERNUS DX8000",
"ETERNUS2000",
"ETERNUS4000", or
"ETERNUS8000"
Target Flag
(cannot be
changed)
TARGET_FLAG Fixed at "1" Fixed at "2" Fixed at "4"

Fujitsu ETERNUS Specifications

General

Brand	Fujitsu
Model	ETERNUS
Category	Storage
Language	English