Chapter 2 Setup
> 2.5 Monitoring Multiple Target Devices
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
36
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
2 Copy an existing setup file.
Example: STXPOLL_1.INI
3 Change the name of the copied file.
Setup file names must start with "STX" and end with ".INI".
Example: STXPOLL_2.INI
4 Edit the copied file. (The STXPOLL_2.INI file is used here.)
Use a text editor such as Note Pad to edit the copied files.
Refer to "2.3 Setting Items" (page 18) for details of how and which parameters should be
changed in the new setup file.
End of procedure
2.5.3 Adding the Extra Target Devices to the Top Menu File
When monitoring multiple target devices, edit the Top Menu file as follows.
Note that if the target device is other than ETERNUS2000, each target address must have either
"/login.htm" or "/login_jp.htm" added to the end.
The following example uses a configuration with two ETERNUS3000s and one ETERNUS2000
to show how the top menu file should be edited to allow all three devices to be monitored. The
top menu file should be edited in the same way when monitoring other devices.
[Example]
• 1st Target Device (ETERNUS3000#1)
Target Address = http://000.000.000.001
Alarm History Files URL = domain-name/eternusmgr/ETERNUS3000_1
• 2nd Target Device (ETERNUS2000#1)
Target Address = http://000.000.000.002
Alarm History Files URL = domain-name/eternusmgr/ETERNUS2000_1
• 3rd Target Device (ETERNUS3000#2)
Target Address = http://000.000.000.003
Alarm History Files URL = domain-name/eternusmgr/ETERNUS3000_2
"_stxpoll.ini" is provided as a model file. If you copy this file to make a
new setup file, be sure to keep the original file as is.
To Next Page
Loading...
Need help?
General
