To Next Page

To Previous Page

ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-

P2X0-0202-04ENZ0

Chapter 3 Startup and Shutdown

This chapter explains how to startup and shutdown ETERNUSmgr.

3.1 ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux

This section explains how to manually startup and shutdown ETERNUSmgr, for Solaris OS, HP-

UX, AIX, and Linux as well as how to set ETERNUSmgr for automatic startup.

3.1.1 Starting Up ETERNUSmgr

Perform the following to start ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux:

Procedure

1 Become the superuser.

# su

2 Execute the execution control script with the start option:

# /opt/FJSVgrmgr/stxpoll start

3 Confirm the daemon is running:

# ps -e | grep stxpolld

999 ? 0:00 stxpolld

End of procedure

After ETERNUSmgr has started up, you need to view the log file to confirm whether or not

ETERNUSmgr is in communication with the target device. If using the E-mail notification

function, also check that E-mail notification of ETERNUSmgr startup and changes in the target

device states is received.

ETERNUSmgr startup can be confirmed by:

• Use the ps command to check that the service is activated.

• Checking the log, and making sure that communication with the target device is normal.

• Checking E-mails, and making sure that communication with the target device is normal (if the

E-mail notification function is used).

When monitoring multiple target devices, you must check each target device separately. For

example, if monitoring three devices, issue the ps command to check that all three devices are

Fujitsu ETERNUS User Manual

Other manuals for Fujitsu ETERNUS