To Next Page

To Previous Page

Chapter 2 Setup

> 2.3 Setting Items

ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-

P2X0-0202-04ENZ0

2 Edit the STXPOLL_1.INI file.

Vi editor is used here.

# vi /opt/FJSVgrmgr/STXPOLL_1.INI

When setting up multiple target devices, copy an existing setup file to make the setup easier. For

details on how to do this, see "2.5

Monitoring Multiple Target Devices" (page 34).

End of procedure

2.2.2 ETERNUSmgr for Windows® Procedure

The following describes how to edit a setup file for ETERNUSmgr for Windows®.

The procedure shown is for changing the settings that were set during installation.

Procedure

1 Confirm the contents of the installation directory using Explorer, etc.

Make sure the following files and folder have been installed in the installation directory:

_stxpoll.ini, STXPOLL.exe, STXPOLL_1.INI, stxpolld.exe, stxsmail.exe, and \www (\www

is a folder).

2 Edit the STXPOLL_1.INI file.

Edit the STXPOLL_1.INI file using a text editor (Notepad, etc.).

End of procedure

2.3 Setting Items

This section explains the setting items (parameters) in the setup files.

2.3.1 Target Device Settings

This section explains the settings that allow ETERNUSmgr to monitor a target device.

■ Target Address

The target address parameter is used to set the IP address or host name assigned to the target

device.

The target port number does not need to be changed (the default number is normally used).

Target address cannot be omitted. ETERNUSmgr will not start if this parameter has not been

set.

Specify SVP IP address if the ETERNUS6000 is using SVP.

Fujitsu ETERNUS User Manual

Other manuals for Fujitsu ETERNUS