TX1320 M4 Upgrade and Maintenance Manual 71
Basic software procedures
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View press the Locate
button in the title bar to switch on the ID indicators.
5.2 Completing the maintenance task
5.2.1 Updating or recovering the BIOS and the iRMC S5
I For Japan:
Follow the instructions provided separately.
After replacing the system board, memory or a CPU, it is essential to upgrade
the BIOS and iRMC to the latest version. The latest BIOS and iRMC versions
are available from the Fujitsu support internet pages at:
http://ts.fujitsu.com/support/
For Japan:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
I Note on the boot watchdog
Before updating or recovering the BIOS and iRMC, ensure that the boot
watchdog is disabled, see section "Disabling the boot watchdog" on
page 68.
After updating or recovering the BIOS and iRMC, enable the boot
watchdog again, see section "Enabling the boot watchdog" on page 81.
I Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.
5.2.1.1 Updating or recovering the BIOS
BIOS flash procedure
Ê Perform the BIOS flash procedure as described in the "BIOS Setup Utility"
reference manual of your server.
BIOS recovery procedure
Ê Perform the BIOS recovery procedure as described in the "BIOS Setup
Utility" reference manual of your server.