90 Upgrade and Maintenance Manual TX1320 M4
Basic software procedures
Checking the label
Ê If available, check the label on the controller.
Beside the part number, you may find the WWN address.
Using an UEFI BIOS
Ê Enter the BIOS setup menu.
Ê Select the Advanced menu.
The addresses are displayed at the Advanced menu main page.
I Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
5.2.16.3 Looking for the GUID address of an infiniband or Omni-Path
controller
There are several possible locations where these addresses can be found.
Ê Inform the customer about the new or changed GUID address.
Checking the label
Ê If available, check the label on the controller.
Beside the part number, you may find the GUID address.
5.2.16.4 Looking for SAS addresses of SAS controllers for external
devices
There are several possible locations where these addresses can be found.
Ê Inform the customer about the new SAS address. The customer need the
new SAS address, especially when the server is connected to a Fujitsu
Storage ETERNUS system.
Using ServerView RAID Manager
Ê Start the ServerView RAID Manager and log in.
Ê Select the desired SAS controller.
In the General tab you can find data on the selected object including its SAS
address.
I For more information, see the "ServerView Operations Manager - Server
Management" user guide and the "ServerView RAID Manager" - user guide.