Fujitsu ScanSnap S510M Getting Started Guide

ScanSnap S510M Getting Started 30
Chapter 5 Daily Care
This chapter describes how to clean the ScanSnap.
5.1 Cleaning Materials
*1) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the ScanSnap
parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner
completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts.
*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.
*3) Any lint-free cloth can be used.
To purchase the cleaning material, contact the store where you purchased the ScanSnap or an authorized
FUJITSU scanner service provider.
5.2 Cleaning the ScanSnap Exterior
Clean the ScanSnap exterior with a cloth moistened with a small amount of neutral detergent or Cleaner
F1 (sold separately).
WARNING
• Before you clean the ScanSnap, unplug the power cable from the power outlet to
prevent from fire or electric shock.
• To avoid injuries, do not place the internal parts (such as the Pad ASSY and pick roller)
in areas where small children can reach.
• Do not use any aerosol sprays or alcohol based sprays to clean the ScanSnap. Dust
blown up by strong air from the spray may enter the inside of the ScanSnap. This may
cause the ScanSnap to fail or malfunction. Sparks, caused by static electricity,
generated when blowing off dust and dirt from the outside of the ScanSnap may cause
a fire.
Cleaning Materials Parts No. Remarks
Cleaner F1 PA03950-0352 1 bottle (100 ml) (*1)
Cleaning wipe PA03950-0419 1 pack (24 sheets) (*2)
Lint-free dry cloth Commercially available. (*3)
ATTENTION
• Never use paint thinner or other organic solvents.
• During the cleaning, prevent water or moisture from getting inside the ScanSnap.
Cloth
Cleaner F1 or
neutral detergent
Paint thinner

Fujitsu ScanSnap S510M Specifications

General

Brand	Fujitsu
Model	ScanSnap S510M
Category	Scanner
Language	English