Fujitsu SP-1125 User Manual

Chapter 1 Scanner Overview
21
Appendix
Glossary
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Index
Introduction
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes without being
used, it automatically enters power saving mode.
Even after the scanner enters power saving mode, the power
indicator remains on.
To resume from power saving mode, perform one of the
following:
 Load a document in the ADF paper chute (feeder).
 Press the scan/stop button on the operator panel.
 Perform scanning from an application.
When the scanner resumes from power saving mode, the
power indicator flashes until the scanner enters ready status.
If the scanner is not operated for a certain period of time, it
turns off automatically to reduce power consumption while the
scanner is in standby.
To disable this function, clear the [Power off after a certain
period of time] check box in [Device Setting] of the Software
Operation Panel. For details, refer to "Waiting Time to Enter
Power Saving Mode (Power saving)" (page 98).
To turn the scanner back on after it has turned off
automatically, press the power button on the operator panel.
For details, refer to "1.3 Turning the Power ON/OFF" (page
16).
1.7 Power Saving Mode
ATTENTION
 The scanner may not enter power saving mode if there was a
document remaining on the paper path.
For details about how to remove a document, refer to "7.1 Paper
Jam" (page 63).
 Depending on the application being used, the scanner might not turn
off even if the [Power off after a certain period of time] check box is
selected.
 If the scanner turns off automatically while you are using an image
scanning application, close the application before you turn the
scanner back on.
HINT
 The waiting time for entering power saving mode can be changed in
the Software Operation Panel.
For details, refer to "Waiting Time to Enter Power Saving Mode
(Power saving)" (page 98).
 For details about the operator panel, refer to "Chapter 3 How to Use
the Operator Panel" (page 38).

Fujitsu SP-1125 Specifications

General

Brand	Fujitsu
Model	SP-1125
Category	Printer
Language	English