1. OPERATION
8
1.9 How to Use the Speed Notice
The speed notice feature provides visual and aural (single beep) notifications when the ship’s
speed is within the range set or higher or lower than a given speed range.
1.9.1 How to set the speed notice
1. Press the MENU/ESC key to open the main menu.
2. Select [1 SPEED], then press the ENT key.
3. Select [1 NOTICE], then press the ENT key. The options pop-up window shown right appears.
4. Select [OFF], [INSIDE] or [OUTSIDE], then press the ENT key.
• [OFF]: Deactivates the speed notice.
• [INSIDE]: The audiovisual notices are released when the speed is within the minimum and
maximum speeds set.
• [OUTSIDE]: The audiovisual notices are released when the speed is under the minimum
speed or over the maximum speed set.
Note: When both the minimum and the maximum speeds are the same, the audiovisual no-
tices are released under the following conditions:
• [INSIDE]: The minimum and maximum speed are lower than the current speed.
• [OUTSIDE]: Current speed is lower than the minimum and maximum speed.
5. Select [3 MINIMUM], then press the ENT key.
6. Use the CursorPad to set the minimum speed, referring to"Numeric data input pop-up win-
dow" in section 1.7.1.
7. Select [4 MAXIMUM]. Set the maximum speed to use, referring to step 6.
8. Set the maximum speed to use, referring to step 6.
9. Press the DISP key to close the menu.
When this feature is activated, the speed notification icon in the status bar changes according to
notice status.
To Next Page
Loading...
Need help?
General
