Furuno FAR-2107 User Manual

1. RADAR OPERATION
1-95
+
34°40.849 N
135°18.303 E
CURSOR DATA
box (L/L position)
1.45.3 Selecting an antenna
For the ship that carries multiple antennas, you may choose the antenna to use
as follows:
1. Roll the trackball to place the arrow in the ANTENNA box at the left side of
the screen.
ANT1 X-BAND (M) 
2. Roll the scrollwheel to choose an antenna then push the left button.
1.46 Cursor Data
Cursor data can be shown in latitude and longitude
position or cursor’s X-Y coordinates, with the C
specification radar.
Left-click the CURSOR DATA box at the right side of the
display to select the cursor data to show. The cursor data
changes in the sequence shown below.
+
34°30.323 N
135°08.263 E
+
9.649NM
9.683NM
Latitude and longitude
position of cursor
Cursor X-Y position
Cursor data options
Note 1: For the X-Y coordinates display, the Y-axis is the heading line, right/top
is "plus" and left/lower is "minus."
Note 2: When displaying latitude and longitude position and the cursor has been
aligned (on the PLOTTER menu), the indication "CHART ALIGN"
appears at the right side of the screen (in yellow).
Note 3: Cursor data reads "- - -.-" when the cursor is placed outside the effective
display area.
Note 4: Cursor bearing format (true or relative) and cursor range unit (nm, sm,
km or kyd) are available as below.
Type
Cursor bearing
format
Cursor
range unit
Menu operation
IMO Yes No
A Yes No
2 [MARK]→9 EBL CURSOR BEARING
B Yes Yes
C Yes Yes
W Yes No
2 [MARK] →9 [EBL, VRM CURSOR SET] →CURSOR
BEARING, CURSOR RANGE

Furuno FAR-2107 Specifications

General

Brand	Furuno
Model	FAR-2107
Category	Marine Radar
Language	English