1. RADAR OPERATION
1-110
9. Push the right button four times to close the menu.
10. Use the EBL offset feature to anchor the net cursor at net origin point.
a) Push the EBL OFFSET key.
b) Use the trackball to set net origin point.
c) Push the EBL OFFSET key to anchor the net cursor.
11. Steer the vessel so your ship’s trail runs along the net cursor then throw the
net.
1.56 User Settings
The function settings shown in the table below can be reset to their default
setting by enabling PILOT SETTING. (Functions not shown below maintain their
previous setting.)
The unit also has the ability to store 2 separate sets for the settings below in its
internal memory. You are also able to recall these settings. (Items not shown
below cannot be stored or recalled.)
Function Settings Remarks
Tuning Maintained as per the
previous setting.
TUNE Box
Range 6 NM RANGE Box
Range Rings OFF [MENU] > 2 [MARK] > 0 [RING]
Display ON VRM1
Distance 0.25 NM
VRM1 Box
Display OFF VRM2
Distance 0.000 NM
VRM2 Box
Display ON
Bearing 0.0 degrees
EBL1 Box
EBL1
Reference TRUE [MENU] > 2 [MARK] > 9 [EBL
CURSOR BEARING] *1
Display OFF
Bearing 0.0 degrees
EBL2 Box
EBL2
Reference TRUE [MENU] > 2 [MARK] > 9 [EBL
CURSOR BEARING] *2
Display
Interval
Orientation
PI LINE Box
Bearing (True or
REL)
[MENU] > 2 [MARK] > 4 [PI LINE] >
2 [PI LINE BEARING]
*3
Numbers(1, 2, 3 or 6) [MENU] > 2 [MARK] > 4 [PI LINE] >
3 [PI LINE]
PI Lines
Mode (Parallel or
Perpendicular)
Maintained as per the
previous setting.
[MENU] > 2 [MARK] > 4 [PI LINE] >
4 [PI LINE MODE]
Presentation Mode NORTH UP TM PRESENTATION MODE Box
Stabilization Mode (Sea or Ground) GPS (Ground stabilization) [SPEED MENU] > 1 [SHIP SPEED]
(Continued on next page)
To Next Page
Loading...
Need help?
General
