2. WIRING
2-38
10. Set the shields of cables under the cable clamp then tighten the cable clamp.
11. Remount the processor unit cover.
2.6 Radar Connection Box RCB-002 (option)
The RCB-002 is capable of connecting the FMD-3u00 with up to two external radar
systems. Referring to the figure below, connect the respective equipment to the RCB-
002.
Connecting LAN cables
When connecting LAN cables (MOD-WPAS0001-030+) to the RCB-002, use the fol-
lowing procedure.
1. Unfasten and remove the sealing nut from the
NETWORK port on the RCB-002, then remove
the seal assembly. See the right figure for ref-
erence.
Lay shields of cables
under this clamp then
tighten the clamp.
RADAR SIGNAL IN No.1
RADAR SIGNAL IN No.2
NETWORK
POWER
To external radar
MJ-A10SPF0020A (5m, 10 m, 20 m, 30 m) cable
To external radar
MJ-A10SPF0020A (5m, 10 m, 20 m, 30 m) cable
To HUB-3000
MOD-WPAS0001-030+
(3 m) cable
To PR-240
MJ-A3SPF cable
To ship`s ground
Ground cable, IV-1.25sq.
Unused
Seal assembly
Seal
Seal nut
Claw
To Next Page
Loading...
Need help?
General
