4. FILE OPERATIONS
4-3
How to prepare a message with both addressee code and password
Type the addressee code as shown in the illustration below and then type the text of
message.
The recipient enters the password to view the contents of the message.
4.2.3 Editor menu settings
The Editor menu sets the parameters of the text editor.
1. Press the F8 key to display the [Setup] menu then press the 2 key to show the
[Editor Setup] menu.
2. Set each item as required, referring to the descriptions below.
Text Mode: Select [Telex] to create a telex message. Only upper case alphabet
is permitted in telex. Use [Ascii] to create an e-mail message. Upper and lower
case alphabet may be used in an e-mail.
Edit Mode: Select [Insert] (insert character at cursor location) or [Overwrite] (write
over character at cursor location).
Word Wrap: Turn automatic hyphenation at the end of a line on or off
Line No.: Turn the line number display on or off. See the illustration below.
Tab Width: Set the horizontal tab width, two, four or eight tabs per line.
Column Width: Set 69 for telex, 40 to 80 for ASCII.
Cursor Type: Select the cursor configuration, block or underline.
Scroll: Sets how much the screen moves up over the page ([Full Screen] or [Half
Screen]) when the Page Up or Page Down key is operated.
S???-addressee code-password: (text of message)
Be sure to enter colon.
maximum 8 characters each
Editor Setup
Ascii
Insert
ON
ON
4 Char
69
Block
Full Screen
Text Mode
Edit Mode
Word Wrap
Line No.
Tab Width
Column Width
Cursor Type
Scroll
<[1] UNTITLED1>
0001|
Cursor can be a square or an underline.
Line Number
Displayed if Line No. is turned on in
Editor Setup menu.
To Next Page
Loading...
Need help?
General
