6. DATA REPORT AND POLLING
6-3
13. [Yes] is selected; press the Enter key to register the settings.
14. Long-press the Esc key to return to the standby display.
6.1.2 How to prepare a message report
1. Press the F5 and 2 keys to show the [Message Report]
menu.
2. Press the appropriate numeric key to select a message re-
port.
PIN code is unrelated to message reporting, however it is necessary for polling
(see section 6.2). Enter PIN code as shown below.
3. [PIN Code] is selected; press the Enter key to open the PIN code entry window.
4. Key in PIN code, using up to eight digits, then press the Enter key. The PIN code
is a password used in message reports. When a ship receives a polling command
w/PIN code from a shore subscriber and the code matches that of the ship, the
ship sends a message report.
5. Select [Status] then press the Enter key.
6. Turn the message report ON or OFF as appropriate then press the Enter key.
7. Select [Station Name] then press the Enter key.
8. Select the station name then press the Enter key.
You may sort the list by group name, station name or communication type as fol-
lows:
Group name: Each press of Ctrl+G sorts the list by group name, ascending or
descending order.
Station name: Each press of Ctrl+N sorts the list by station name, in ascending
or descending order.
Comm. type: Each press of Ctrl+T sorts the list by communication type, in as-
cending or descending order.
9. For e-mail do step 1) and 2) below. For other communication formats, go to step
10.
1) Select [Subject] then press the Enter key.
Mesasge Report
1. Message Report 1
2. Message Report 2
3. Message Report 3
4. Message Report 4
Message Report
OFF
TELEX/MES
Regular Interval
00:10
1 (---: No Limit)
--:--
--:--
--:--
--:--
NAV
PIN Code
Message Report Programming
Status
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Destination
Modem Type
Address
Subject
LES ID
Activation
Interval Time
Report Times
Start Time1
Start Time2
Start Time3
Start Time4
Report Contents
File