EasyManuals Logo
Home>Furuno>Marine Radar>INMARSAT-C FELCOM 18

Furuno INMARSAT-C FELCOM 18 User Manual

Furuno INMARSAT-C FELCOM 18
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
6. DATA REPORT AND POLLING
6-8
6.3 DNID (Data Network Identification)
When you make a contract with an information provider, DNIDs are downloaded from
the information provider to the FELCOM, via the appropriate LES.
Up to 64 DNIDs can be downloaded to the FELCOM. You can see which DNIDs are
stored by following the procedure shown below.
6.3.1 How to display DNIDs
You need to make a contract with an LES to exchange data within a group. The LES
sends a DNID (Data Network Identification) number to each member of the group. The
FELCOM can store a maximum of 64 DNIDs.
Press the F5 and 4 keys to show the [Data Network ID] list.
“Act” indications and their meanings
Asterisk: Enabled DNID
No indication means disabled DNID.
24h: Enabled DNID. TX cycle changes every 24 hours.
STP: Enabled DNID. TX temporarily disabled.
6.3.2 How to enable, disable DNIDs
Note: The [Disable], [Enable (24-hour)] and [Enable (Temporary Stop)] settings
are for LRIT only. Only use these settings with a DNID for LRIT.
1) When anchored or docked, the [Enable (24-hour)] and [Enable (Temporary Stop)]
settings can be used to temporarily stop of send 24-hour interval reports.
2) When the setting is changed from [Enable (24-hour)] or [Enable (Temporary Stop)]
to [Enable], reports are sent at 6-hour intervals again. Where DNID is set to a DNID
other than for LRIT and [Enable (24-hour)] or [Enable (Temporary Stop)] is select-
ed, change the setting to [Enable] then ask the administrator for a compatible
DNID for LRIT and request a polling command from the land station.
3) The interval reports can be stopped by selecting [Disable]. Interval reports will not
be sent after reverting the setting to [Enable]. To reinstate the interval reports,
change the setting to [Enable] then ask the administrator for a compatible DNID for
LRIT and request a polling command from the land station. Where the DNID is not
compatible with LRIT, follow the procedure mentioned above, even when selecting
[Disable].
Data Network ID
Mark '*' means activation. Ctrl+P: Print
No.
01
02
03
04
05
06
07
08
Act
*
24h
STP
*
24h
STP
DNID
01000
01001
01002
01003
01004
01005
01006
01007
LES
002
001
102
131
202
210
302
304
Subaddr
000
001
002
003
004
000
001
002
Member
235
085
215
033
227
013
079
089
Text
Sub address
Member number using DNID

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Furuno INMARSAT-C FELCOM 18 and is the answer not in the manual?

Furuno INMARSAT-C FELCOM 18 Specifications

General IconGeneral
BrandFuruno
ModelINMARSAT-C FELCOM 18
CategoryMarine Radar
LanguageEnglish

Related product manuals