3. SYSTEM INITIALIZATION
3-3
3.2 Terminal Setup
The [Terminal Setup] menu provides for selection of connection point, date display for-
mat, screen saver on/off and window colors.
1. Press the F8 and 3 keys to show the [Terminal Setup] menu.
2. For a 2nd DTE, do steps 1) - 2) below. Otherwise, skip to step 3.
1) Select [Connection] then press the Enter key to show the [Connect List]. The
[Connect List] shows the names of the FELCOM 18 terminals available for
communication.
Note: The No. Name, IMN, IP address/subnet mask and software version of
each terminal are shown. The asterisk marks the FELCOM 18 terminal cur-
rently selected for communication.
2) Select the FELCOM 18 terminal to connect then press the Enter key.
3. Select [Date Disp. Form] then press the Enter key to open its options window.
4. Select [YY-MM-DD], [MMM-DD-YY] or [DD-MMM-YY] as appropriate then press
the Enter key.
5. Select [Screen Saver] then press the Enter key.
6. Turn the screensaver ON or OFF as appropriate then press the Enter key. When
enabled, the screensaver automatically starts 10 minutes after there is no key op-
eration. To release the screensaver, press any key.
Connection
Date Disp. Form DD-MMM-YY
Screen Saver OFF
Window Color
Window Size Normal
Terminal Setup
Date Disp. Form DD-MMM-YY
Screen Saver OFF
Window Color
Terminal Setup
IC-218 2nd DTE
No. Name IMN IP Address Software Version
01 F18_123456 123432588 172.31.16.2 1650247-xx
02 F18_133234 456789210 192.168.16.2 1650247-xx
03
04
05
06
07
08
09
10
Other
Connection List
To Next Page
Loading...
Need help?
General
