26
Fusion Troubleshooting
My Fusion does not turn on.
• Charge Fusion for at least 30 minutes.
• Press the small reset button (see diagram on pg. ii).
My Fusion screen is too light or too dark.
• Rotate the contrast adjustment screw
(see diagram on pg. ii).
The red light does not come on when the unit
is plugged into the recharger.
• Press the reset button.
The text to speech has too much static sound.
• Press and hold the reset button in for 30 seconds, then
release.
My Fusion lost the text to speech program.
• Press and hold the reset button in for 30 seconds then
release.
When sending to a computer, I’m seeing
misspelled words or extraneous characters.
• Make sure that the rear of the Fusion is aligned with the
infrared receiver and is no closer than 5 inches.
• Try turning off the lights in the room and then send the
document into the computer. If the document comes out
correctly, then there is interference from the fl orescent
lighting. You may need to shade your Fusion infrared
receiver with a small piece of paper.
Fusion Op Guide 0509.indd Sec1:26Fusion Op Guide 0509.indd Sec1:26 5/22/09 1:22:40 PM5/22/09 1:22:40 PM
To Next Page
Loading...
General