nüvi 2405/2505 Series Owner’s Manual 1
Getting Started
WARNING
See the Important Safety and Product
Information guide in the product box for product
warnings and other important information.
1
Connect the device to vehicle power
(page 1).
2
Mount the device (page 1).
3
Register the device (page 3).
4
Check for updates.
• Software updates (page 3).
• Free map update (page 3).
Connecting the Device to Vehicle
Power
WARNING
This product contains a lithium-ion battery.
To prevent the possibility of personal injury or
product damage caused by battery exposure
to extreme heat, remove the device from the
vehicle when exiting or store it out of direct
sunlight.
Before you use your device on battery power,
you should charge it.
1
Plug the vehicle power cable ➊ into the
USB port on the device
➋.
2
Snap the mount ➌ onto the suction cup ➍.
3
Press the suction cup to the windshield, and
ip the lever
➎ back toward the windshield.
4
Fit the bottom of your device into the mount.
5
Tilt your device back until it snaps into place.
To Next Page
Loading...
Need help?
General